(the tapered side) Make a square with the two measurements that you just acquired.(Don't cut out yet) Lay the base board next to the side and make marks on where the notches are. Cut the piece out.įirst find the height of the screen and add 1/8 of an inch. (notches may be different depending on the distance you choose the screen to be) Cut the piece out and trace it onto foam board. Duplicate on the other side and make sure the distance from the corner of the goggles to first notch is the same. The notches should be 1 cm deep and 1 1/4 inch long, space the two with another inch. Make notches on the line that was just drawn. (the same length from Picture 5) From the corner of the goggles to the very far line Draw a line with a straight edge.(Picture 8) Do the same on the other side. Draw another line where the back of the screen would be. (Make sure you use a square) From the leading edge of the goggles measure out the distance you want the screen (step 3's measurement) Find the length of the screen and center it on the line(picture 5) Then find the width of the screen and and add that measurement from the line where the screen would sit. Trace the top part of the goggles onto the foam board, find the middle of the Goggles and draw a straight line out. Start by popping out the lens of the ski goggles. Ski Goggles or 3D glasses - i got mine from Wm- around $15 Bucks but you can pick this, which is better (save money and material)Ģnd option (can skip some steps if you buy these) ($13.99)ģrd option (can skip some steps if you buy these) ($14.99) The goggles consist of a 4.3 inch LCD screen, Foam board, Ski Goggles, and Duct tape (color) So i came up with a solution! A DIY pair you can make for $42! Sure the experience isn't as great as what you would get from a Fatshark or other high end FPV goggles, but its definitely worth the 42 bucks! Sadly the cheapest FPV goggles out there is around $150. In my opinion the best way to enjoy FPV is with video goggles.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |